3” Pro Series Channel Drains
3” Pro Series Channel Drains
The 3” Pro Series Channel only available in 39-3/8” (3.28’) sections. The channel can be easily cut to any length.
The 3” Pro Series Channel grates are only available in light grey.
No. The only grate available for the 3” Pro Series Channel a high impact PVC grate.
The plastic grate is rated to support automobiles, light trucks, and medium-duty pneumatic tires (up to 175 psi) at speeds less than 20 m.p.h.
The 3” Pro Series Channel can be purchased in a kit that includes the channel, 2 grates, an end cap, and an end cap with outlet (NDS part # 764). The channel, end caps, end cap with outlets, and grates can also be purchased separately.
There are no prefabricated accessories for the 3” Pro Series Channel to make bends, however, the channel can be cut to any angle using a miter saw. The same angle will need to be cut into another piece of channel. Glue the pieces together and secure the joint before encasing in concrete.
Sections of 3” Pro Series Channel can be connected using the interlocking end joints.
There are two options to drain the water out of the 3” Pro Series Channel; the end of the channel or the bottom of the channel. Each outlet connects to a 3” sewer and drain pipe.
We recommend a 1/8” gap be left between grates during installation to allow for expansion of the grates.
The channel itself will hold about the same volume of water as a 4” diameter pipe.
The 3” Pro Series Channel is made from PVC. PVC glue can be used to glue all pieces together.
The grates can be screwed to the channel using NDS part # 229 – Stainless Steel Screws, Phillips Head #8 x 1” screws (screws sold separately).
