What is the Flo-Well load rating?
FAQs
What is the Flo-Well load rating?
What is the Flo-Well load rating?
The minimum depth that a Flo-Well should be buried is 8” from the surface to the top of the FloWell. When buried to this depth, it is rated to support light vehicular traffic (loads up to 175 psi). The Flo-Well can be buried to depths up to 8’ deep. The Flo-Well will support heavier loads at this depth, but the type of soil above the Flo-Well will determine the maximum load that can be supported.
Category
Drainage
Flo-Well FAQs
- How much water can each Flo-Well hold?
- How many Flo-Wells do I need?
- What parts come in the Flo-Well box?
- Can multiple Flo-Wells be attached to the same drainage system?
- What is the maximum number of Flo-Wells that can be stacked?
- Is the Flo-Well bottom necessary?
- What is the Flo-Well load rating?
- How do I install the center support pipe?
- How many of the 1” drain holes should be removed?
- What material should be used to backfill around the Flo-Well?
- Do I need the fabric wrap?
- How much drain rock do I need?
- How much distance should there be between Flo-Wells?
- Is an overflow necessary?
- Can I connect my washing machine to a Flo-Well?
- How do I install the Surface Drain Inlet with Grate (FWSD69) if my Flo-Well is more than 8” below the surface?
